YSC

Description

A mouse passthrough adapter built on its own USB stack and its own low-level firmware — written from scratch rather than assembled out of open-source pieces. It speaks both the COM-port protocol and the kmboxnet network protocol, so it drops straight into whatever DMA or AI software you already run.

8 KHz support — the full range

• Full 125–8000 Hz range – the whole polling range is supported, not just the headline number
• Clean at every rate – even 1 KHz mode transmits a stable, uncorrupted signal
• No ceiling – high-speed devices run at full tilt

Custom firmware — closed loop, no leak

• Dedicated USB stack – built from scratch, not pieced together from open-source code
• Low-level firmware – written for this device specifically
• Closed-loop architecture – nothing leaks out of the loop

COM + NET dual protocol

• COM-port protocol – direct serial connection
• kmboxnet network protocol – connect over the network instead
• Any DMA or AI software – pick whichever connection suits your build

Also on board

• Controller passthrough – controllers are carried through as well as mice
• Custom mouse serial number – set the serial the device reports
• Mouse interpolation – smoother movement between reports

In the box

• 1 × YSC adapter

Mouse, PC and cables are not included. Not sure whether it fits your setup? Ask us on Discord before you order.